On the entrypad:

1. Press Menu/OK then 1
2. Login as Administrator or Manager
3. Enroll your 1st finger print, by placing it on the sensor. Enroll a 2nd fingerprint or press the Back button to skip fingerprint enrollment. 
4. The screen will prompt Set code? To skip code enrollment, press Back, to enroll a code press Menu/OK.
5. If setting a code, enter new code (6 digits) then repeat new code to enroll new user.

On the entrypad:

1. Press Menu/OK then 2
2. Login as Administrator or Manager
3. Press ▼ to select the user and press Menu/OK
4. Press Menu/OK to confirm deletion

You can delete individual users in the SECURAM Smart app. 

On the entrypad:

1. Press Menu/OK then Menu/OK again
2. Login as Administrator or Manager
3. Press ▼ to find “Pair Phone” and press Menu/OK
4. Follow the pair process in the SECURAM Smart app.

The Prologic Smart safe lock uses a 9V to operate. 

1. Locate the SureLock battery compartment at the 5 o’clock position of the entrypad. 
2. Release the latch of the battery compartment by pulling the lever downward.
3. Pull out the battery compartment and remove the spent 9V battery. 
4. Install a new 9V battery into the compartment. (The compartment will only receive the battery when the positive and negative terminals are oriented correctly. 
5. Put the battery compartment back in to the entrypad. Push the latch of the compartment up until it snaps closed.

On the entrypad:

• Enter your code followed by Menu/OK.
  • Example: 1 2 3 4 5 6 -> Menu/OK
• To mask your code, you can enter up to 9 digits – your 6-digit code plus up to 3 additional digits. 
  • Enter 3-4-1-2-3-4-5-6-7, wher e the 2 masking digits before your code (3-4) and the single masking digit after your code (7) are concealing or masking your actual code.
  • If you enter less than 9 digits, you must always press the Menu/OK button to send the code to the lock.
  • Note: the additional 3 masking digits can be added before and/or after your code.
  • Enter 3-4-1-2-3-4-5-6-7, where the 2 masking digits before your code (3-4) and the single masking digit after your code (7) are concealing or masking your actual code.
  • If you enter less than 9 digits, you must always press the Menu/OK button to send the code to the lock.
  • Note: the additional 3 masking digits can be added before and/or after your code. 

• In the SECURAM app, tap unlock then enter valid code (includes one time access code)

The ProLogic Smart Safe Lock automatically re-locks after 6 seconds.